|
|
Prices are subject to change
| MODEL FPJ-25-P PROP/JET | ||||
| Repair Parts - Lower Drive Assembly | ||||
| Item | ||||
| Number | Part Number | Description | ||
| 1 | 250229 | Gear Case Housing | ||
| 2 | 250230 | End Cap – Rear | ||
| 3 | 250231 | End Cap – Front | ||
| 4 | 250232 | “O”-Ring Drive Housing Tube | ||
| 5 | 250233 | Bearing, ½” I.D. | ||
| 6 | 250234 | “O”-Ring; End Cap Seal | ||
| 7 | 207036 | Driven Spiral Bevel Gear | ||
| 8 | 250236 | Propeller Shaft | ||
| 9 | 58130-ZV0-841ZB | Propeller | ||
| 10 | 250237 | Shaft Seal, ½” I.D. | ||
| 11 | 250238 | Guard, Front | ||
| 12 | 250239 | Guard, Rear | ||
| 13 | 250173 | Zinc, Anode | ||
| 14 | 250157 | Flatwasher ¼” S/S | ||
| 15 | 250149 | ¼” Split Lockwasher S/S | ||
| 16 | 250154 | ¼”-20 Hex Nyloc S/S | ||
| 17 | 250240 | ¼”-20 x 1½” HHCS S/S | ||
| 18 | 250142 | ¼”-20 x ¾” HHCS S/S | ||
| 19 | 90757-ZV0-000 | Cotter Pin | ||
| *20 | 250241 | E-Ring, Propeller Shaft | ||
| 21 | 250217 | 3/16” Key x 1” Long | ||
| 22 | 250218 | ¼”-20 x ¼” Cup Point Set Screw | ||
| 23 | 250242 | 10-24 x 1/8” Cup Point Set Screw | ||
| 24 | 58131-ZV0-000 | Shear Pin | ||
| End Cap–Rear, can be purchased as a sub-assembly with one (1) Part #250233 Bearing installed. Refer to Part #250301. | ||||
| End Cap-Front, can be purchased as a sub-assembly with one (1) Part #250233 Bearing installed and two (2) Part #250237 Shaft Seals installed. Refer to Part #250302. | ||||
| *Note: Assembly requires only (1) "E"-Ring. Depending on the type of driven gear being used will determine in which goove the "E"Ring will be installed. For Model FPJ-4P the "E"-Ring would be positioned in the groove closest to the end of the propeller shaft. For Model FPJ-25-P the "E"-Ring would be positioned in the forward groove. | ||||
